Table of Contents
Advertisement
You have not logged in to the
target NetWare server with
supervisor privileges.
Initializing the Network Interface
To initialize your network interface, turn on the device, and then
plug the power cord of the network interface into a wall outlet
while holding down the status sheet button of the network
interface for twenty seconds. The length of time necessary to hold
down the status sheet button varies depending on the device
model. The green USB light flashes, indicating the network
interface is being initialized.
After the initialization is complete, press the status sheet button
to print a status sheet. Check the information on the status sheet.
Note:
You can also initialize the network interface using EpsonNet Config by
clicking the Default Settings button.
Restrictions on EPSON Status Monitor 3
The operation of EPSON Status Monitor 3 is different, depending
on whether the printer or all-in-one is connected to the network
interface for use in the wireless LAN environment or to the
computer directly, as described below.
From the computer on which EpsonNet
Config is installed, log in to the target
NetWare server with supervisor
privileges.
275
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 802.11g and is the answer not in the manual?
Questions and answers
my rx620 epson printer will not print any thing on the paper but the fist 3 cartridges are down to half full and the other 3 are close and i dont know where all the ink is going . the printer as working fine then just stopped printing goes through all the motions like it is