Epson 802.11g Reference Manual page 21

How To
Overview
This section describes the general procedure on how to set up the
network interface for use on a network.
1. Check the network interface operation.
Check the functions and operations of the network interface,
such as status lights, status sheet button, USB connector,
DC-IN connector, and security lock. See "Network Interface
Operation" for details.
2. Select a printing method.
Select a printing method appropriate for your network
environment and operating system. If you are not sure, see
"Printing from Windows" or "Printing from Macintosh" for
details.
3. Install the necessary components on your computer.
Make sure the necessary components (such as TCP/IP,
NetBEUI, etc.) are installed on the computer, and network
settings (such as IP address, subnet mask, etc.) of the
computer is set. See "About Installing Components on Your
Computer" for details.
4. Insert the Software CD-ROM in the CD-ROM drive to
configure the network interface.
If you are using one of the following Epson devices, see "For
Windows" or "For Macintosh" for details.
21