Table of Contents
Advertisement
Using the NET USE command
If you are running Windows XP/Server 2003/2000/NT and using
NetBIOS to connect to the device, we recommend that you use the
NET USE command, as follows:
1. Right-click the Network Neighborhood icon or My Network
Places icon and then select Properties.
2. Check that Client for Microsoft Networks is in the
Components list. If it is not installed, click Add to install it.
3. Run the command prompt and enter the following command.
NET USE printer port: \\NetBIOS name of network
interface\Device name of network interface
Selecting the port
1. Click Start, point to Settings, and then select Printers.
2. Right-click the printer icon and select Properties.
3. Click the Details tab and select the port you have set with the
NET USE command.
Windows Server 2003
For Windows Server 2003, the printer driver installation
procedure differs depending on the printing method you prefer.
Epson recommends printing with EpsonNet Print. See "For
Windows XP/Server 2003/2000/NT 4.0 Users".
118
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 802.11g and is the answer not in the manual?
Questions and answers
my rx620 epson printer will not print any thing on the paper but the fist 3 cartridges are down to half full and the other 3 are close and i dont know where all the ink is going . the printer as working fine then just stopped printing goes through all the motions like it is