Table of Contents
Advertisement
3. Clear the Access the Internet using a proxy server check
box.
Configuring the Network Interface Using
EpsonNet Config
After you have assigned an IP address to the network interface
using EpsonNet EasyInstall, EpsonNet Config for Windows or
Macintosh, or the arp/ping command, you can configure the
network interface using Web-based EpsonNet Config.
Note:
A Web browser must be installed on your computer.
TCP/IP must be correctly set for the computer and the network
interface.
Do not run both EpsonNet Config for Windows or Macintosh and
Web-based EpsonNet Config at the same time.
Your browser may restrict some characters you can use. For details,
see your browser or operating system documentation.
If you are using the dial-up environment and not using NetWare,
select Disable on the NetWare screen. If Enable is selected, the
extra account may be charged when you are using the dial-up router.
Follow the steps below to change the IP address using EpsonNet
Config.
1. Turn on the device.
2. Run EpsonNet Config using one of the following ways.
Run EpsonNet Config for Windows or Macintosh. Select
the device you want to configure from the list and then
click Launch Browser.
150
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 802.11g and is the answer not in the manual?
Questions and answers
my rx620 epson printer will not print any thing on the paper but the fist 3 cartridges are down to half full and the other 3 are close and i dont know where all the ink is going . the printer as working fine then just stopped printing goes through all the motions like it is