Table of Contents
Advertisement
If the device power is off or there is a problem on the network,
the Get status every 20 sec check box is automatically
cleared. If this happens, make sure that the device power is on
and the device is correctly connected on the network, and then
select the Get status every 20 sec check box again.
5. Click OK to save settings.
6. When a message appears saying the settings are correctly
configured, click OK to start the Add Printer Wizard. Click
Next.
Note:
If you click Cancel and then later want to add the device, start the
Add Printer Wizard and follow the steps below.
7. Click the Local printer radio button and click Next.
8. Select the printer driver and click Next.
If the following dialog box appears, select Replace existing
driver and click Next.
196
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 802.11g and is the answer not in the manual?
Questions and answers
my rx620 epson printer will not print any thing on the paper but the fist 3 cartridges are down to half full and the other 3 are close and i dont know where all the ink is going . the printer as working fine then just stopped printing goes through all the motions like it is