Led Light And Smv Bracket Installation (After August, 2013) - Landoll VT Plus 7431 Operator's Manual

7-PIN 4-PIN CIRCUIT
CONN TOWER
1 D GROUND
2 WORK LAMPS
3 B LEFT FLASHING
& TURN
4 STOP LAMPS
5 A RIGHT FLASHING
& TURN
6 C TAIL LAMPS
7 SWITCHED
POWER (12V)
FRONT WARNING
HARNESS
m177034 elect wire designations op
Figure 3-23: LED Light and SMV Harness Wire Designations (After August, 2013)
LED Light and SMV Bracket
Installation (After August, 2013)
NOTE
Refer to pages 2-8 thru 2-17 for light bracket
placements.
1. Attach left and right light brackets with reflectors to
center frame using u-bolts and hex lock nuts (See
Figure 3-22.)
2. Attach ag amber single LED lamps to light brackets
using 1/4-20 x 1-1/4 hex head cap screws and hex
lock nuts.
3. Attach left tail light mount to frame assembly using
u-bolt and 5/8-11 flange head serrated nuts.
4. Attach right tail light mount and ag flasher control
module to frame assembly using u-bolt and 5/8-11
flange head serrated nuts. Be sure that the control
module is set so that the 6 pin connector faces the
right side of the machine.
5. Attach the ag red single LED lamps to tail light
mounts using 1/4-20 x 1-1/4 hex head cap screws
and hex lock nuts.
WIRE
COLOR
GROUND
BLACK
BLACK
LEFT TURN
YELLOW
WHITE
GROUND
RED
BROWN
GREEN
TAIL LIGHT
YELLOW
BROWN
LEFT TURN
BLUE
GREEN
RIGHT
RED
RIGHT
IMPORTANT
Make sure lights are positioned for maximum
visibility from the rear.
6. Install the rear warning light harness to the frame.
7. Attach front warning harness to frame. Connect 4 pin
8. Insure that the harnesses are clear of any moving
9. Install the stor-away holder to hose holder on hitch
10. Attach SMV emblem and mounting bracket to rear
ASSEMBLY INSTRUCTIONS
1 2
2-PIN 3-PIN
TOWER TOWER
A A
B
B
TURN
C
TURN
REAR WARNING
HARNESS
Connect 2 pin and 3 pin ends to each of the warning
lights. Connect 6 pin to the ag flasher control module.
See Figure 3-23 for LED harness wire
designations.
end to the ag flasher control module.
parts and secure the harnesses with tie wraps
provided.
with 1/4-20 x 3/4 hex head cap screws and hex lock
nuts.
center frame bar using u-bolt, 1/4-20 x 3/4 hex head
cap screws, and hex lock nuts. The SMV sign should
be centered on the back bar of the frame.
3 4 5
6-PIN 3-PIN 2-PIN
SHROUD TOWER TOWER
C
A
A
B A
B
C
D B
E
F
3-29