Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
Coulter Gang Installation
Coulter blades are extremely sharp. Exercise
extreme care when working on or near coulter
blades. Do not allow coulters to roll over or fall
onto any body part. Do not allow wrenches to slip
when working near coulter blades. Never push
wrenches toward coulter blades. Do not climb
over machine above coulter blades. Failure to
stay clear of coulter blade edges can cause
serious personal injury or death.
1. Attach the coulter gang assemblies to the center and
wing frames using coulter pivot pin, 1 lock nut, and
1/2 x 2-1/4 roll pin
See Figure 3-6
Figure 3-7
for gang assembly placement.
2. Attach the base end of the 4 x 8 master cylinder to
the coulter spring assembly attached to the left wing
frame weldment using the clevis pins and roll pins
provided with cylinder.
t
3-10
DANGER
and
See
3. Attach the base end of the 3-3/4 x 8 cylinder to the
coulter spring assembly attached to the left center
frame weldment using the clevis pins and roll pins
provided with cylinder.
4. Attach the base end of the 3-1/2 x 8 cylinder to the
coulter spring assembly attached to the right center
frame weldment using the levis pins and roll pins
provided with cylinder.
5. Attach the base end of the 3-1/4 x 8 cylinder to the
coulter spring assembly attached to the right wing
frame weldment using the clevis pins and roll
pinsprovided with cylinder.
6. Connect the rod ends of each cylinder to the gang
bar cylinder anchor plate using the clevis pins and
roll pins provided with cylinder.
7. The hydraulics may be installed see
Installation" on page
"Hydraulic
3-18.
F-1099-0521
Advertisement
Table of Contents
