Variable Ratio Adjustment - Landoll 2132 Operator's Manual

OPERATION AND MAINTENANCE

Variable Ratio Adjustment

The leveler is equipped with a variable ratio adjustment.
Connect the leveler tube assembly to the middle hole in
the center wheel lift for normal operation. This will cause
the rear of the machine to raise higher than the front
increasing transport height. The lower hole on the center
lift provides an increased leveler ratio, which will cause
the Coulter Chisel to become more level in transport. The
lower hole should be used when a rear tow hitch is
needed to reduce the height of the rear tow hitch during
transport. The upper hole on lift provide less leveler ratio,
which will cause the rear of the machine to raise higher
than the center hole. Further increase the rear height.
2-1/2 JAM
NUTS
ADJUSTMENT
WRENCHES
HITCH
ASSEMBLY
4-8
LEVELER TUBE
WELDMENT
RADIUS
ASSEMBLY
Figure 4-9: Variable Ratio Leveler Adjustment
1. To change the variable ratio adjustment, lower the
implement to the ground and relieve the load on the
lift system.
2. Extend or retract the radius assembly, until the load is
removed from the leveler tower.
3. To adjust the leveler tube weldment at the center
wheel lift, remove the hitch pin, 1" lock nut.
4. Reinstall the hitch pin, 1" lock nut in the leveler tube
assembly to the center lift in the desired position.
ADJUSTMENT HOLES
ON CENTER WHEEL LIFT
HITCH PIN,
1" LOCK NUT
F-1099-0521