Leveling (Front-To-Rear); Leveling (Side To Side) - Landoll 2132 Operator's Manual

Leveling (Front-to-Rear)

1. The leveling feature on the 2132 Coulter Chisel is
used to keep the machine level when raising the unit
from a working position to a transport position. The
leveling feature is also used to level the unit from
front-to-rear to perform a level operation in the field.
2. The unit should be level from front to rear. This will
reduce horsepower requirements, allow a more
uniform tillage operation, and reduce unnecessary
point wear.
3. To adjust the leveling feature, loosen jam nuts at
each end of the radius rod using the adjustment
wrenches See Figure
Coulter Chisel, lengthen the radius rod assembly. To
lower the front of the Coulter Chisel, shorten the
radius rod assembly. After adjusting, re-tighten jam
nuts at each end. Adjustments should be made in
small increments.
2-1/2 JAM NUTS
Figure 4-6: Radius Rod Leveling Adjustment

Leveling (Side to Side)

1. Leveling the 2132 Coulter Chisel side-to-side
involves leveling the wing frame to the center frame.
The unit should be level side-to-side when operating
in the field.
4-6. To raise the front of the
ADJUSTMENT
WRENCHES
OPERATION AND MAINTENANCE
2. To level the unit, verify that all tires are properly
inflated. With the implement unfolded, raise the unit
to fully extend the lift cylinders. Continue to hold the
tractor lever 30-60 seconds to insure that the
cylinders are fully extended and the rephasing lift
system has been purged of air. Lower the unit until
the coulter points are approximately 1" off the
ground. On the center frame, measure the distance
from the walking beam spindle to the top side of the
frame See Figure 4-7. Set wing frames 1-1/8" higher
than the center frame. Adjusting the anchor at the
base end of each wing lift cylinder sets wing frame
height See Figure 4-8.
Figure 4-7: Leveling from Side to Side
3. An adjusting wrench is provided (stored on hitch
assembly) to make this adjustment. It may be
necessary to lower the wing to the ground and relieve
weight on the cylinder anchor to make this
adjustment. If required, fully raise the implement,
lower to just above the ground, and re-verify
measurements. Repeat as necessary and securely
tighten the cylinder anchor when complete.
WING ASSEMBLY
BASE END CYLINDER
ANCHOR ADJUSTMENT
1-3/4 JAM
NUTS
Figure 4-8: Wing Lift Adjustment
MEASURE
CENTER FRAME,
+ 1-1/8" FOR WINGS
4 X 16
CYLINDER
TIRE/WHEEL
LIFT ASSEMBLY
4-7