Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
3BCT/Chopper Reel Installation
(Option)
NOTE
Refer to
See Figures 2-14
for Standard 3BCT/Chopper Reel Placement.
Refer to
See Figures 2-24
for Hydraulic 3BCT/Chopper Reel Placement.
1. Attach the combo harrow mount arm long
assemblies on rear of center frame and short arm
assemblies to plates on rear of wing frames with 3/4
x 2-1/2 bolts, 3/4 flat washers, 3/4 lock nuts
Figures
3-26.
2. Remove the 5/8 x 3-11/16 x 6-3/8 u-bolts, 5/8 flange
lock nuts, harrow stiffner plates from harrow
adjustment tubes.
3. Attach the harrow tine assemblies, secure with the
u-bolts, harrow stiffner plates, nuts that were just
removed as shown
See Figures 3-26
4. Remove the 3/4 x 5-1/2bolts, 3/4 lock nuts, gangbar
mount plates from harrow mount arms.
5. Attach the reel assemblies, secure with the gangbar
mount plates, 3/4 x 5-1/2bolts, 3/4 lock nuts, that
were just removed as shown
6. On all Models attach the wrench mount with 1/2 x
8-1/2 bolt, 1/2 flat washer, 1/2 lock nut to the left
center frame arm assembly only.
7. On hydraulic 3BCT/Chopper Reel option, install the
hose mount plate with the 1/2 x 8-1/2 bolt, 1/2 flat
washer, 1/2 lock nut, the hose clamp attaches with
3/8 x 1-1/2 bolt, 3/8 flat washer, 3/8 lock nut.
8. On hydraulic 3BDT/Chopper Reel option, install the 8
port manifold to manifold mount with 1/2 x 4-1/2
bolts, 1/2 lock nuts as shown
8 PORT MANIFOLD,
1/2 X 4-1/2 BOLT,
1/2 LOCK NUT
Figure 3-23: 8 Port Manifold Installation
3-34
through
See Figures 2-23
through
See Figures 2-33
See
See Figures
3-26.
See Figures
3-23.
MANIFOLD MOUNT
BRACKET
9. On hydraulic 3BCT/Chopper Reel option, install the
bulkhead tee w/nut and 90° adapter swivel to plate on
frame as shown
See Figures
BULKHEAD
NUT
PLATE
Figure 3-24: Bulk Head Fittings Installation
10. On hydraulic 3BDT/Chopper Reel option, attach
hoses down through the slotted holes of combo
harrow mount arm to cylinders as shown
Figures
3-25. The one hose hooks to base end of
cylinder to top set of holes of 8 port manifold, rod end
to bottom holes of manifold.
SLOTTED HOLES
ROD END
CYLINDER
Figure 3-25: Hose to Cylinder Installation
11. On hydraulic 3BCT/Chopper Reel option,
Figures 3-27
through
hydraulic installation.
3-24.
BULKHEAD
TEE W/NUT
90 ° ADAPTER
SWIVEL
See
6"
BASE END
CYLINDER
See
See Figures 3-29
for proper
F-1099-0521
Advertisement
Table of Contents
