Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
4 FOOT
Figure 3-40: 1,200 Foot-Pounds of Torque
Final Assembly
1. Attach a tractor to the implement and charge the lift
system hydraulics as described in
System" on page
4-2.
2. Install the 2 x 16 transport lockouts on both 4-1/2 x
16 master cylinders on the center frame.
3. The fold systems must be purged of air and filled with
oil BEFORE attempting to fold the implement. Air in
the system will allow the wings to fall uncontrollably
and may result in implement damage. Follow
instructions for charging the hydraulic fold system as
described in
"Hydraulic Fold System" on page
3-50
4. Connect lights to the tractor and verify operation.
5. Check tires for proper inflation
300
6. Level the Wing Coulter Chisel from front to rear as
POUNDS
PULL
7. Inspect the final implement assembly, and verify that
8. Rotate each coulter gang to verify that each gang
9. Lubricate the Wing Coulter Chisel at all locations as
10. Touch up with paint any areas that may have been
"Hydraulic Lift
14. Thoroughly read and understand the operating
4-4.
described in
"Leveling (Front-to-Rear)" on
page
4-7.
all bolts have been tightened, cotter pins spread, and
that there are no leaking hydraulic connections.
CAUTION
Tighten all 1-3/4" nuts to 1,250 foot-pounds of
torque
(See Figure
3-40)
rotates freely. Adjust any scrapers that may have
shifted during shipment or assembly.
described in
"Lubrication Schedule" on page
scratched during moving, handling, or assembly.
section before using the Coulter Chisel.
4-13.
F-1099-0521
Advertisement
Table of Contents
