Chopper Reel Installation (Option) - Landoll 2132 Operator's Manual

ASSEMBLY INSTRUCTIONS
Chopper Reel Installation
(Option)
NOTE
Refer to See Figures 2-34
for Standard Chopper Reel Placement.
Refer to See Figures 2-46
for Hydraulic Chopper Reel Placement.
1. Attach the chopper arm long assemblies on rear of
center frame and short arm assemblies to plates on
rear of wing frames with 3/4 x 2-1/2 bolts, 3/4 flat
washers 3/4 lock nuts
2. Remove the 3/4 x 5-1/2bolts, 3/4 lock nuts, gangbar
mount plates from harrow mount arms.
3. Attach the reel assemblies, secure with the u-bolts,
gangbar mount plates, nuts that were just removed
as shown See Figures
4. On hydraulic Chopper Reel option, install the hose
mount plate with the 1/2 x 8-1/2 bolt, 1/2 flat washer,
1/2 lock nut, the hose clamp attaches with 3/8 x 1-1/2
bolt, 3/8 flat washer, 3/8 lock nut.
5. On hydraulic Chopper Reel option, install the 8 port
manifold to manifold mount with 1/2 x 4-1/2 bolts, 1/2
lock nuts as shown See Figures
8 PORT MANIFOLD,
1/2 X 4-1/2 BOLT,
1/2 LOCK NUT
Figure 3-30: 8 Port Manifold Installation
6. On hydraulic Chopper Reel option, install the
bulkhead tee w/nut and 90° adapter swivel to plate on
frame as shown See Figures
3-40
through See Figures 2-43
through See Figures 2-53
See Figures 3-33.
3-33.
3-30.
MANIFOLD MOUNT
BRACKET
3-31.
BULKHEAD
NUT
PLATE
Figure 3-31: Bulk Head Fittings Installation
7. On hydraulic Chopper Reel option, attach hoses
down through the slotted holes of combo harrow
mount arm to cylinders as shown
The one hose hooks to base end of cylinder to top
set of holes of 8 port manifold, rod end to bottom
holes of manifold.
SLOTTED HOLES
ROD END
CYLINDER
Figure 3-32: Hose to Cylinder Installation
8. On hydraulic Chopper Reel option,
through See Figures 3-36
installation.
BULKHEAD
TEE W/NUT
90 ° ADAPTER
SWIVEL
See Figures 3-32.
6"
BASE END
CYLINDER
See Figures 3-34
for proper hydraulic
F-1099-0521