Coulter Gang Installation - Landoll 2130 Operator's Manual

3-7 COULTER GANG INSTALLATION

DANGER
COULTER BLADES ARE EXTREMELY
SHARP. EXERCISE EXTREME CARE
WHEN WORKING ON OR NEAR COUL-
TER BLADES. DO NOT ALLOW COUL-
TERS TO ROLL OVER OR FALL ONTO
ANY BODY PART. DO NOT ALLOW
WRENCHES TO SLIP WHEN WORKING
NEAR COULTER BLADES. NEVER
PUSH WRENCHES TOWARD COUL-
TER BLADES. DO NOT CLIMB OVER
MACHINE ABOVE COULTER BLADES.
FAILURE TO STAY CLEAR OF COUL-
TER BLADE EDGES CAN CAUSE SERI-
OUS PERSONAL INJURY OR DEATH.
3-7.1 Attach the coulter gang assemblies to
the center and wing frames using shank pin,
1-8 hex lock nut, and 1/2 x 2-1/4 grooved al-
loy pin (See Figure 3-5).
3-7.2 Attach the base end of the 4 x 8 master
cylinder to the coulter spring rod assembly
attached to the left wing frame weldment us-
ing the clevis pins and roll pins which come
with the cylinder and a steel bushing.
3-7.3 Attach the base end of the 3-3/4 x 8
slave 1 cylinder to the coulter spring rod as-
sembly attached to the left center frame
weldment using the clevis pins and roll pins
which come with the cylinder and a steel
bushing.
3-7.4 Attach the base end of the 3-1/2 x 8
slave 2 cylinder to the coulter spring rod as-
sembly attached to the right center frame
weldment using the clevis pins and roll pins
which come with the cylinder and a steel
bushing.
3-7.5 Attach the base end of the 3-1/4 x 8
slave 3 cylinder to the coulter spring rod as-
sembly attached to the right wing frame
weldment using the clevis pins and roll pins
which come with the cylinder and a steel
bushing.
3-7.6 Connect the rod ends of each cylinder
to the gang bar cylinder anchor plate using
the clevis pins and roll pins which come with
each cylinder.
o
3-7.7 Install 90
the 4 x 8 master cylinder, 3-3/4 x 8 slave 1
cylinder, 3-1/2 x 8 slave 2 cylinder, and the
base end port of the 3-1/4 x 8 slave 3 cylin-
der.
o
3-7.8 Install 90
rod end of the 3-1/4 x 8 slave 3 cylinder.
adapters into both ports of
elbow w/ restrictor into the
3-11