Table of Contents
Advertisement
Disc Gang and Depth
Adjustment Installation
Disc blades are extremely sharp. Exercise
extreme care when working on or near disc
blades. Do not allow disc to roll over or fall onto
any body part. Do not allow wrenches to slip
when working near disc blades. Never push
wrenches toward disc blades. Do not climb over
machine above disc blades. Failure to stay clear
of disc blade edges can cause serious personal
injury or death.
1-8 X 12 HEX HEAD
CAP SCREW
2211-13-15 radius rod inst
DANGER
Figure 3-10: Top View of Radius Rod Installation - 2211-13 & -15
ASSEMBLY INSTRUCTIONS
1. Assemble the disc gang lift to the frame. Install the 4"
UHMW bearings and bearing caps using 3/4-10 x 2
hex head cap screws and hex lock nuts (See
Figures 3-8 and 3-9.)
2. Install 4 x 8 hydraulic cylinder with rod pointing up to
the frame weldment using the clevis pins and roll
pins which come with each cylinder.
o
3. Install 2- 90
elbow w/ restrictor into the butt end of
the cylinder.
NOTE
Assemble front gangs first to prevent machine from
tipping over backwards.
IMPORTANT
For proper operation, the 90
must be the same in each end of the 4 x 8 hydraulic
cylinder.
REAR GANGS
4-1/2" SPACER
1-3/4" SPACER
DOUBLER PLATE
FRONT GANGS
o
elbows w/ restrictors
3-15
Advertisement
Table of Contents
