Table of Contents
Advertisement
Coulter Gang Installation
Coulter blades are extremely sharp. exercise
extreme care when working on or near coulter
blades. Do not allow coulters to roll over or fall
onto any body part. Do not allow wrenches to slip
when working near coulter blades. Never push
wrenches toward coulter blades. Do not climb
over machine above coulter blades. Failure to
stay clear of coulter blade edges can cause
serious personal injury or death.
DANGER
ASSEMBLY INSTRUCTIONS
1. Attach the coulter gang assemblies to the frame
using shank pin, 1-8 hex lock nut, and 1/2 x 2-1/4
grooved alloy pin (See Figure 3-5.)
2. Attach the base ends of the 4 x 8 master and 3-3/4 x
8 slave hydraulic cylinders to the coulter spring rod
assembly attached to the frame weldment using the
clevis pins and roll pins which come with each
cylinder.
3. Connect the rod ends of each cylinder to the gang
bar cylinder anchor plate using the clevis pins and
roll pins which come with each cylinder.
o
4. Install 90
adapters into both ports of the 4 x 8
master cylinder and the base end port of the 3-3/4 x
8 slave cylinder.
o
5. Install 90
elbow w/ restrictor into the rod end of the
3-3/4 x 8 slave cylinder. Note that this is the only
location with a restrictor fitting used on the Coulter
Chisel.
3-11
Advertisement
Table of Contents
