Disc Gang Installation - Landoll WEATHERPROOFER II 2320 FOLD Series Operator's Manual

3-3 DISC GANG INSTALLATION

WARNING
TO PREVENT SERIOUS INJURY OR
DEATH, READ ALL SAFETY PRECAU-
TIONS AT THE FRONT OF THIS SEC-
TION BEFORE ATTEMPTING ANY OF
THE FOLLOWING PROCEDURES.
IMPORTANT
SEE FIGURE 3-3 FOR PART NAMES.
DANGER
DISC BLADES ARE EXTREMELY
SHARP. EXERCISE EXTREME CARE
WHEN WORKING ON OR NEAR DISC
BLADES. DO NOT ALLOW DISCS TO
ROLL OVER OR FALL ONTO ANY BOD-
I LY PA R T.
WRENCHES TO SLIP WHEN WORKING
NEAR DISC BLADES. NEVER PUSH
WRENCHES TOWARDS DISC BLADES.
DO NOT CLIMB OVER MACHINE
ABOVE DISC BLADES. FAILURE TO
STAY CLEAR OF DISC BLADE EDGES
CAN CAUSE SERIOUS PERSONAL IN-
JURY OR DEATH.
WARNING
DO NOT ATTEMPT TO LIFT THE DISC
GANGS MANUALLY. USE A HOIST OR
A FORK LIFT TO MOVE THE DISC
GANGS INTO POSITION.
D O NO T ALLOW
3-3.1 FRONT DISC GANG INSTALLATION
IMPORTANT
THE FRONT DISC GANGS HAVE A 13 INCH
SPACING.
a. Install the pivot block on the outer disc gang
frame pivot so the long end is facing the rear.
b. Hoist the disc gang up until the inner ball
socket hanger goes into the mount on the
main frame and the outer pivot block is be-
hind the frame mounting bracket.
c. Align the pivot block with the frame mount-
ing bracket and slide the disc gang forward.
d. Install the hitch pin and 1/4 x 2-1/2 cotter
pins on the inner mounting bracket.
e. Install a 1-8 x 6 hex head cap screw with
the disc adjust stop bushing and hex lock nut
in the outer disc mounting bracket to retain
the pivot block. Bolt threads up.
3-3.2 REAR DISC GANG INSTALLATION
IMPORTANT
THE REAR DISC GANGS HAVE A 10 INCH
SPACING.
a. Install the pivot block on the outer disc
gang frame pivot so the long end is facing the
front.
b. Hoist the disc gang up until the inner ball
socket hanger goes into the mount on the
main frame and the outer pivot block is in
front of the frame mounting bracket.
c. Align the pivot block with the frame mount-
ing bracket and slide the disc gang rearward.
d. Install the hitch pin and 1/4 x 2-1/2 cotter
pins on the inner mounting bracket.
e. Install a 1-8 x 6 hex head cap screw with
the disc adjust stop bushing and hex lock nut
in the outer disc mounting bracket to retain
the pivot block. Bolt threads up.
3-7