Table of Contents
Advertisement
3-6 COULTER GANG INSTALLATION
DANGER
COULTER BLADES ARE EXTREMELY
SHARP. EXERCISE EXTREME CARE
WHEN WORKING ON OR NEAR COUL-
TER BLADES. DO NOT ALLOW COUL-
TERS TO ROLL OVER OR FALL ONTO
ANY BODY PART. DO NOT ALLOW
WRENCHES TO SLIP WHEN WORKING
NEAR COULTER BLADES. NEVER
PUSH WRENCHES TOWARD COUL-
TER BLADES. DO NOT CLIMB OVER
MACHINE ABOVE COULTER BLADES.
FAILURE TO STAY CLEAR OF COUL-
TER BLADE EDGES CAN CAUSE SERI-
OUS PERSONAL INJURY OR DEATH.
3-6.1
Attach the coulter gang assemblies to
the frame using shank pin, 1-8 hex lock nut,
and 1/2 x 2-1/4 spring slotted pin (See Fig-
ure 3-5).
3-6.2
Attach the base ends of the 4 x 8 mas-
ter and 3-3/4 x 8 slave hydraulic cylinders to
the coulter spring rod assembly attached to
the frame weldment using the clevis pins and
roll pins which come with each cylinder.
3-6.3
Connect the rod ends of each cylinder
to the gang bar cylinder anchor plate using
the clevis pins and roll pins which come with
each cylinder.
o
3-6.4
Install 90
the 4 x 8 master cylinder and the base end
port of the 3-3/4 x 8 slave cylinder.
o
3-6.5
Install 90
rod end of the 3-3/4 x 8 slave cylinder. Note
that this is the only location with a restrictor
fitting used on the Coulter Chisel.
adapters into both ports of
elbow w/ restrictor into the
3-11
Advertisement
Table of Contents
