Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
Unloading the HSL and Final
Assembly
I
n most cases the 7831 HSL has come to you with the
main wheels and tires shipped loose due to shipping
width, restrictions.
1. Install the main wheels and tires to the hitch rock
shaft hubs (See Figure 3-1.)
2. Due to the HSL being a towed implement the tire
tread is typically installed opposite of that of a tread
where power would be applied through it. For
instructions and specifications on torqueing the lug
nut assemblies, (See Figure 3-1 and Table 2-1.)
3-2
NOTE
There is a protruding step on the hub pilot. The wheel
center plate must fit over the hub pilot and then bottom
out against the hub flange. Failure to get the wheel
properly positioned against the hub face will cause the
wheel to loosen and cause damage to the hub and/or
wheel.
3. With the tire and wheel assembly correctly positioned
4. Re-check the positioning of the wheel relative to the
Figure 3-1: Tire and Wheel Installation
against the hub, begin to tighten the flange nuts
sequentially as shown on decal 3-573-010210 in
(Figure 3-1) to 50 foot pounds.
hub and proceed by tightening the lug nut assemblies
sequentially to 450 to 500 foot pounds.
F-801-1115 Edition
Hide quick links:
Advertisement
Table of Contents
