Final Assembly - Landoll VT PLUS 7430 Operator's Manual

3-14 FINAL ASSEMBLY

3-14.1 Attach a tractor to the implement and
charge the lift system hydraulics as de-
scribed is Section 4-4.
3-14.2 Install the transport locks on both 4 x 10
master cylinders on the center frame.
3-14.3 Connect the hydraulic hoses on the op-
tional hydraulic leveler to the tractor (if
equipped). Fully extend and retract the hy-
draulic leveler several times to remove any
air. See Section 4-10 for any further adjust-
ments
3-14.4 The fold system must be purged of air
and filled with oil BEFORE attempting to fold
the implement. Air in the system will allow
the wings to fall uncontrollably and may re-
sult in implement damage. Follow instruc-
tions for charging the hydraulic fold system
(See Section 4-5).
3-14.5 Connect lights to the tractor and verify
operation.
3-14.6 Check tires for proper inflation
3-14.7 Level the disc from side to side as de-
scribed in Section 4-8.
3-14.8 Inspect the final implement assembly,
and verify that all bolts have been tightened,
cotter pins spread, and that there are no
leaking hydraulic connections.
3-14.9 Rotate each disc gang to verify that
each gang rotates freely. Adjust any scrap-
ers that may have shifted during shipment or
assembly.
3-14.10 Lubricate the disc at all locations (See
Section 4-20).
3-14.11 Touch up with paint any areas that
may have been scratched during moving,
handling, or assembly.
3-14.12 Thoroughly read and understand the
operating section before using the disc.
3-33