Table of Contents
Advertisement
3-12 FINAL ASSEMBLY
3-12.1
Attach a tractor to the implement and
charge the lift system hydraulics as de-
scribed is Section 4-4.
3-12.2
Install the 1-1/2 x 16 lockouts on both
3-1/2 x 16 cylinders on the frame.
3-12.3
Connect lights to the tractor and verify
operation.
3-12.4
Check tires for proper inflation
3-12.5
Level the Coulter Chisel from front to
rear as described in Section 4-8.
3-12.6
Inspect the final implement assembly,
and verify that all bolts have been tightened,
cotter pins spread, and that there are no
leaking hydraulic connections.
3-13 OFFSET SHANK MOUNT INSTALLATION (OPTION)
If back row of shanks continually plug with resi-
due, offset shank mounts are available for the back
row of shanks. Contact the Landoll Corporation
Service department for more information.
Figure 3-12 1,200 Foot-Pounds of Torque
3-22
CAUTION
TIGHTEN ALL 1-3/4" NUTS TO 1,200
FOOT-POUNDS OF TORQUE (SEE FIG-
URE 3-12).
3-12.7
Rotate each disc gang to verify that
each gang rotates freely. Adjust any scrap-
ers that may have shifted during shipment or
assembly.
3-12.8
Lubricate the Coulter Chisel at all loca-
tions (See Section 4-15).
3-12.9
Touch up with paint any areas that may
have been scratched during moving, han-
dling, or assembly.
3-12.10
Thoroughly read and understand the
operating section before using the Coulter
Chisel.
3-13.1
If offset shank mounts are used, bolt to
the rear frame using u-bolts, and 3/4-10 hex
lock nuts (See Figure 3-13).
3/4-10 HEX LOCK NUT
12" OFFSET MOUNT
REAR FRAME
WELDMENT TUBE
U-BOLT
offset mount op
Figure 3-13 Offset Shank Mount Installation
Advertisement
Table of Contents
