Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
Final Assembly
1. Attach a tractor to the implement and charge the lift
system hydraulics as described in "Hydraulic Lift
System" on page 4-2.
2. Install the 1-1/2 x 16 lockouts on both 3-1/2 x 16
cylinders on the frame.
3. Connect lights to the tractor and verify operation.
4. Check tires for proper inflation
5. Level the Coulter Chisel from front to rear as
described in "Leveling (Front-to-Rear)" on
page 4-5.
6. Inspect the final implement assembly, and verify that
all bolts have been tightened, cotter pins spread, and
that there are no leaking hydraulic connections.
Tighten all 1-3/4" nuts to 1,200 foot-pounds of
torque (See Figure 3-12.)
4 FOOT
2md410-010943
Figure 3-12: 1,200 Foot-Pounds of Torque
7. Rotate each disc gang to verify that each gang
rotates freely. Adjust any scrapers that may have
shifted during shipment or assembly.
8. Lubricate the Coulter Chisel at all locations (See
"Lubrication Maintenance" on page 4-12.)
9. Touch up with paint any areas that may have been
scratched during moving, handling, or assembly.
10. Thoroughly read and understand the operating
section before using the Coulter Chisel.
3-20
CAUTION
300
POUNDS
PULL
Offset Shank Mount Installation
(Option)
If back row of shanks continually plug with residue, offset
shank mounts are available for the back row of shanks.
Contact the Landoll Corporation Service department for
more information.
1. If offset shank mounts are used, bolt to the rear
frame using u-bolts, and 3/4-10 hex lock nuts (See
Figure 3-13.)
3/4-10 HEX LOCK NUT
12" OFFSET MOUNT
REAR FRAME
WELDMENT TUBE
U-BOLT
offset mount op
Figure 3-13: Offset Shank Mount Installation
F-479-0310 Edition
Advertisement
Table of Contents
