Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
Final Assembly
1. Attach a tractor to the implement and charge the lift
system hydraulics as described is "Hydraulic Lift
System" on page 4-3.
2. Install the 1-1/2 x 16 lockouts on both 3-1/2 x 16
cylinders on the frame.
3. Connect lights to the tractor and verify operation.
4. Check tires for proper inflation
5. Level the Disc Chisel from front to rear as described
in "Leveling (Front-to-Rear)" on page 4-7.
6. Inspect the final implement assembly, and verify that
all bolts have been tightened, cotter pins spread, and
that there are no leaking hydraulic connections.
Tighten all 1-3/4" nuts to 1,200 foot-pounds of
torque (See Figure 3-25.)
3-28
CAUTION
7. Rotate each disc gang to verify that each gang
rotates freely. Adjust any scrapers that may have
shifted during shipment or assembly.
8. Lubricate the Disc Chisel at all locations (See
"Lubrication Maintenance" on page 4-17.)
9. Touch up with paint any areas that may have been
scratched during moving, handling, or assembly.
10. Thoroughly read and understand the operating
section before using the Disc Chisel.
4 FOOT
2md410-010943
Figure 3-25: 1,200 Foot-Pounds of Torque
300
POUNDS
PULL
F-571-0511 Edition
Advertisement
Table of Contents
