Product Overview
Figure 41
1. Engine hood
2. Operator's seat
3. Control arm
Controls
Figure 42
1. Tilt steering lever
2. Slope indicator
3. Forward traction pedal
Traction Pedals
Press the traction forward pedal
forward. Press the traction reverse pedal
42) to move backward or to assist in stopping when
moving forward. Also, allow the pedal to move or
move it to the
NEUTRAL
4. Steering wheel
5. Front cutting units
6. Rear cutting unit
4. Reverse traction pedal
5. Indicator slot
6. Mow/transport slide
(Figure
42) to move
(Figure
position to stop the machine.
Mow/Transport Slide
Using your heel, move the mow/transport slide
42) left to the T
position.
•
The cutting units only operate when the
mow/transport slide is in the M
•
The cutting units do not lower when the
mow/transport slide is in the T
Tilt-Steering Lever
Pull the tilt-steering lever
steering wheel to the desired position. Then push the
lever forward to secure the position.
Indicator Slot
The slot in the operator platform
when the cutting units are in the center position.
g336464
Slope Indicator
The slope indicator
angle of the machine in degrees.
Control Console
g353291
1. Cutting-unit shift lever
2. Cutting-unit drive switch
3. Oil-pressure light
4. Engine coolant
temperature light
5. Hour meter
6. Glow-plug indicator light
Cutting Unit Shift Lever—Raise/Lower
•
To lower the cutting units to the ground, push
forward the cutting unit shift lever forward to the
L
position
OWER
28
position or right to the M
RANSPORT
OW
RANSPORT
(Figure
42) back to tilt the
(Figure
(Figure
42) indicates the side hill
Figure 43
7. Throttle
8. Alternator light
9. Ignition switch
10. Lift lever lock
11. Parking brake
(Figure
43).
(Figure
OW
position.
position.
42) indicates
g353346