Toro Reelmaster 3100-D Operator's Manual page 17

1. Pivot-shaft link
Assembling the Lift Arms to the
Machine
1. Assemble the lift arms onto the lift arm pivot
shafts as shown in
1. Bolt (1/2 x 2 inches)
2. Pivot-shaft link
2. Assemble pivot-shaft link to the lift arm pivot
shafts (Figure 11) with the 2 flange capscrews
(1/2 x 2 inches) that you removed in
to Install the Lift Arms (page
3. Torque the capscrews to 95 N∙m (70 ft-lb).
Assembling the Lift Cylinder to
the Left Lift Arm
Grease type: No. 2 lithium grease
1. Align the cap end of the lift cylinder with the
holes in the left lift-arm flanges
Figure 10
2. Lift arm pivot shaft
Figure 11).
Figure 11
3. Lift arm
4. Lift arm pivot shaft
Preparing
16).
(Figure
g011161
1. Grease fitting
2. Lift arm flange (left)
3. Snap ring
2. Assemble the cylinder to the flanges with the
mounting pin and 2 snap rings
3. Apply No. 2 lithium grease to the grease fittings
of the lift arm and the hydraulic cylinder
12).
Assembling the Lift Cylinder to
the Right Lift Arm
Grease type: No. 2 lithium grease
1. Align a drain pan below the hydraulic fittings of
the lift cylinder
g346437
2. At the lift cylinder, loosen the straight swivel
fitting of the return hose and the 90° swivel fitting
of the lift hose
12).
17
Figure 12
4. Mounting pin
5. Lift cylinder (cap end)
(Figure
(Figure 13).
Figure 13
(Figure 14).
g346438
12).
(Figure
g346441