Toro Reelmaster 3100-D Operator's Manual page 19

Figure 17
1. Pivot tube (front-carrier
frame)
2. Carriage bolt (3/8 x 2-1/4
inches)
3. Plate (front carrier frame)
2. Align a washer between the carrier plate and
link (Figure 17), and loosely assemble the plates
and spacer with a carriage bolt (3/8 x 2-1/4
inches), washer, and flange locknut (3/8 inch).
Note:
If you are starting assembly at the back of
the cutting unit, use the middle hole of the plate.
3. Repeat step 2 at the other plate holes and links.
4. Torque the flange locknuts to 37 to 45 N∙m (27
to 33 ft-lb).
5. Repeat steps 1 through
cutting unit and carrier frame.
Assembling the Cutting Unit and
Rear Carrier Frame
Cutting Unit with Links
Note:
The rear carrier frame is part of the optional
lift arm kit.
1. Align the hole in the plates rear-carrier frame
with the hole in the cutting unit mounting plates
g353162
4. Washer
5. Link (cutting unit)
6. Flange locknut (3/8 inch)
4 for the other front
1. Carriage bolt (3/8 x 2-1/4
inches)
2. Plate (rear carrier frame)
3. Washer
2. Align a washer between the carrier plate and
link (Figure 18), and loosely assemble the plates
and spacer with a carriage bolt (3/8 x 2-1/4
inches), washer, and flange locknut (3/8 inch).
Note:
If you are starting assembly at the back of
the cutting unit, use the middle hole of the plate.
3. Repeat step 2
4. Torque the flange locknuts to 37 to 45 N∙m (27
to 33 ft-lb).
Assembling the Carrier Frames for
the Front Cutting Units
Cutting Unit with Mounting Plates
Note:
The front carrier frames are part of the optional
lift arm kit.
1. Align the holes in the plates of the front-carrier
frame with the holes in the cutting unit mounting
plates (Figure
19
Figure 18
4. Link (cutting unit)
5. Flange locknut (3/8 inch)
at the other plate holes and links.
19).
g353110