Fuel System Maintenance; Servicing The Fuel Tank; Inspecting The Fuel Lines And Fittings; Draining The Water Separator - Toro Reelmaster 3100-D Operator's Manual

5. Before removing the filter, use low-pressure
air—276 kPa (40 psi), clean and dry—to help
remove large accumulations of debris packed
between the outside of primary filter and the
canister. Avoid using high-pressure air which
could force dirt through the filter into the intake
tract. This cleaning process prevents debris
from migrating into the intake when you remove
the primary filter.
6. Remove the filter element
Note:
Cleaning the used element may damage
the filter media.
7. Remove the rubber outlet valve
the dirt ejection port of the air-cleaner cover.
8. Clean the ejection and outlet valve, and install
the outlet valve to the port.
Installing the Air Filter
1. Inspect the new filter for shipping damage and
check the sealing end of the filter and the body.
Important:
Do not use a damaged element.
2. Insert the new filter by applying pressure to the
outer rim of the element to seat it in the canister.
Important:
Do not apply pressure to the
flexible center of the filter.
3. Install the cover orienting the rubber outlet valve
in a downward position—between approximately
5 o'clock to 7 o'clock when viewed from the end.
4. Secure the cover with the 2 latches.
5. Close and latch the hood.
(Figure 72).
(Figure 72) from
50
Fuel System
Maintenance

Servicing the Fuel Tank

Service Interval: Every 2 years—Drain and clean the
fuel tank.
Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
Drain and clean the tank if the fuel system becomes
contaminated or if the machine will be stored for an
extended period. Use clean fuel to flush out the tank.
Inspecting the Fuel Lines
and Fittings
Service Interval: Every 400 hours/Yearly (whichever
comes first)
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Unlatch and open the hood.
3. Inspect the fuel lines and fittings for deterioration,
damage, or loose connections.
Note:
Repair or replace any damaged or worn
the fuel lines or fittings.
4. Close and latch the hood.
Draining the Water
Separator
Service Interval: Before each use or daily
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Unlatch and open the hood, and wait for the
engine to cool.
3. Place a clean container under the fuel filter.
4. Loosen the drain valve on the bottom of the filter
canister (Figure 73).
44).
44).
44).