Mower Manifold - Toro Reelmaster 3100-D Operator's Manual

Note:
The cutting units do not lower unless the
engine is running. You do not need to hold the
lever in the forward position while the cutting units
are lowered.
•
To raise the cutting units, pull the shift lever
rearward to the R
AISE
Note:
The reels do not run while the cutting units
are raised.
Cutting Unit Shift Lever—Side Shift
Model 03171
Move the lever to the right or left to move the cutting
units in the same direction. Sideshift the cutting units
only when they are raised or if they are on the ground
and the machine is moving.
DANGER
Shifting the cutting units downhill decreases
machine stability. This could cause a rollover,
which may result in personal injury or death.
Shift the cutting units uphill while on a side
hill.
Cutting Unit Drive Switch
The cutting unit drive switch
positions: E and D
NGAGE
operates a solenoid valve on the valve bank to drive
the cutting units.
Oil Pressure Warning Light
The oil pressure warning light
engine oil pressure drops below a safe level.
Engine Coolant Temperature Warning Light
The temperature warning light
if the engine coolant temperature is high. At this
temperature, the cutting units shut off. If the coolant
temperature rises another 5.5°C (10°F), the engine
shuts off to prevent further damage.
Hour Meter
The hour meter (Figure
machine operation. The hour meter starts to function
whenever the key switch is on.
Glow-Plug Indicator
The glow-plug indicator light
when the glow plugs are energized.
Throttle
Move the throttle (Figure
engine speed and rearward to decrease the engine
speed.
position.
(Figure 43) has 2
. The rocker switch
ISENGAGE
(Figure 43) glows if the
(Figure 43) illuminates
43) indicates the total hours of
(Figure 43) illuminates
43) forward to increase the
Alternator Light
The alternator light
engine runs. If the alternator light illuminates while the
engine runs, check the charging system and repair
it as necessary.
Ignition Switch
Use the ignition switch
and lights. The ignition switch has 3 positions:
•
The S O position shuts off the engine.
HUT FF
•
The R /P
UN REHEAT
run or preheats the cylinder head of the engine.
•
The S position energizes the starter.
TART
Note:
When the key is in the R
the glow plug energizes and the indicator light
illuminates for approximately 7 seconds.
Lift Lever Lock
Move the lift lever lock
the cutting units from dropping.
Parking Brake
Whenever the engine is shut off, engage the parking
brake (Figure 43) to prevent accidental movement of
the machine. To engage the parking brake, pull up
on the lever; to disengage the brake, push down the
lever.
Note:
The engine shuts off if you press the traction
pedal with the parking brake engaged.

Mower Manifold

The mower manifold is located under the
control-console cover
1. Backlap control
Reel Speed Knob
Use the reel speed knob of the mower manifold to
adjust the clip rate (reel speed) of the cutting units
(Figure 44).
29
(Figure 43) shuts off when the
(Figure 43) to run the engine
position allows the engine to
/P
UN REHEAT
(Figure 43) rearward to prevent
(Figure 44).
Figure 44
2. Reel speed control
position,
g353378