Installing The Cutting Units - Toro Reelmaster 3100-D Operator's Manual

1. Pivot tube (front-carrier
frame)
2. Carriage bolt (3/8 x 1-1/4
inches)
3. Plate (front carrier frame)
2. Align a spacer between the carrier plate
and mounting plate
assemble the plates and spacer with a carriage
bolt (3/8 x 1-1/4 inches) and flange locknut (3/8
inch).
Note:
If you are starting assembly at the back
of the cutting unit, use the middle holes of each
plate.
3. Repeat step 2 at the other plate holes.
4. Torque the flange locknuts to 37 to 45 N∙m (27
to 33 ft-lb).
5. Repeat steps 1 through
cutting unit and carrier frame.
Assembling the Cutting Unit and
Rear Carrier Frame
Cutting Unit with Mounting Plates
Note:
The rear carrier frame is part of the optional
lift arm kit.
1. Align the holes in the plates of the rear-carrier
frame with the holes in the cutting unit mounting
plates (Figure 15).
Figure 19
4. Spacer
5. Mounting plate (cutting
unit)
6. Flange locknut (3/8 inch)
(Figure 19), and loosely
4 for the other front
g353163
1. Carriage bolt (3/8 x 1-1/4
inches)
2. Plate (rear carrier frame)
3. Spacer
2. Align a spacer between the carrier plate
and mounting plate
assemble the plates and spacer with a carriage
bolt (3/8 x 1-1/4 inches) and flange locknut (3/8
inch).
Note:
If you are starting assembly at the back
of the cutting unit, use the middle holes of each
plate.
3. Repeat step
4. Torque the flange locknuts to 37 to 45 N∙m (27
to 33 ft-lb).
8

Installing the Cutting Units

No Parts Required
Procedure
1. Slide a thrust washer onto each front lift arm
pivot rod.
2. Slide the cutting unit carrier frame onto the pivot
rod and secure it with a lynch pin
Note:
On rear cutting unit, position the thrust
washer between the rear of the carrier frame
and the lynch pin.
20
Figure 20
4. Mounting plate (cutting
unit)
5. Flange locknut (3/8 inch)
(Figure 16), and loosely
2 at the other plate holes.
(Figure
g353096
21).