Checking The Slope Indicator - Toro Reelmaster 3100-D Operator's Manual

1. Positive (+) battery cable
Important:
If you ever remove the battery,
ensure that the battery clamp bolts are
installed with the bolt heads positioned on
the bottom side and the nuts on the top side.
If the clamp bolts are reversed, they may
interfere with the hydraulic tubes when you
shift the cutting units.
7. Coat both battery connections with Grafo 112X
skin-over grease (Toro Part No. 505-47) or light
grease to prevent corrosion.
8. Slide the rubber boot over the positive terminal
to prevent a possible short from occurring.
9. Install the battery cover.
4
Checking the Slope
Indicator
Parts needed for this procedure:
1 Angle indicator (handheld)
Procedure
1. Park the machine on a flat, level surface.
2. Verify that the machine is level by placing a
handheld angle indicator (supplied with the
machine) on the frame cross rail, by the fuel
tank (Figure 6).
Figure 5
2. Negative (–) battery cable
1. Cross rail (frame)
g011213
3. If the angle indicator does not read 0°, move the
machine to a location where you can attain a 0°
reading on the handheld angle indicator.
4. Check the slope indicator mounted on the
steering tube of the machine
Note:
The slope indicator should read 0° when
viewed from the operator's position.
1. Angle indicator
5. If the slope indicator does not read 0°, loosen
the 2 screws and 2 locknuts securing the angle
indicator to the mounting bracket, adjust the
indicator to attain a 0° reading, and tighten the
screws and nuts.
15
Figure 6
2. Handheld angle indicator
(Figure 7).
Figure 7
g353081
g008873