Installing The Tipper Roller Kit (Optional) - Toro Reelmaster 3100-D Operator's Manual

Figure 38
1. CE hood latch
4. Remove the backing and apply the CE decal
Part No. 133-8095 to the frame as shown in
Figure 38.
Applying the CE Tilt Danger Decal
1. Wipe clean the tilt decal on the slope indicator
with alcohol, and allow the decal to dry
39).
Figure 39
1. Tilt decal (slope indicator)
2. Remove the backing and apply the CE tilt danger
decal to the tilt decal on the slope indicator
(Figure 39).
g352025
2. CE decal (Part No.
133-8095)
(Figure
g353161
2. CE tilt danger decal (Part
No. 121-3598)
15
Installing the Tipper Roller
Kit (Optional)
Parts needed for this procedure:
1 Tipper roller kit (not included)
Procedure
When cutting in higher heights of cut, install the Tipper
Roller Kit.
1. Raise the cutting units all the way up.
2. Locate the frame bracket above the center
cutting unit (Figure
3. While pressing down on the front roller of the
center cutting unit, determine which holes on the
tipper bracket align with the frame bracket holes
to attain the same roller contact when the tipper
bracket is installed
1. Frame bracket
4. Lower the cutting units and mount the tipper
bracket to the frame with the 2 carriage bolts
and 2 nuts supplied with the kit
27
40).
(Figure 40).
Figure 40
2. Tipper bracket
(Figure
g016925
40).