Changing The Engine Oil And The Filter; Servicing The Air Cleaner - Toro Reelmaster 3100-D Operator's Manual

Changing the Engine Oil
and the Filter
Service Interval: After the first 50 hours
Every 150 hours
Crankcase capacity: approximately 3.8 L (4.0 US
qt) with the filter
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Unlatch and open the hood, and wait for the
engine to cool.
3. Remove either drain plug
the oil flow into a drain pan; when the oil stops
flowing, install the drain plug.
Figure 70
1. Drain plugs
4. Remove the oil filter
Figure 71
1. Oil filter
5. Apply a light coat of clean oil to the new filter
seal and install the oil filter.
Note:
Do not overtighten the filter.
44).
(Figure 70) and let
(Figure 71).
6. Add oil to the crankcase; refer to
Specification (page 48)
Engine-Oil Level (page
7. Close and latch the hood.

Servicing the Air Cleaner

Service Interval: Every 200 hours (more frequently in
Removing the Air Filter
•
Check the air cleaner body for damage which
could cause an air leak. Replace it if it is damaged.
Check the whole intake system for leaks, damage,
or loose hose clamps.
•
Service the air cleaner at the recommended
service interval or earlier if engine performance
declines due to extremely dusty, dirty conditions.
Changing the air filter before it is necessary only
increases the chance of dirt entering the engine
when the filter is removed.
•
Ensure that the cover is seated correctly and seals
with the air-cleaner body.
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Open the hood.
g008911
3. Release the latches that secure the air-cleaner
cover to the air-cleaner body
g352242
1. Air-cleaner cover
2. Filter element
4. Remove the cover from the air-cleaner body.
49
Engine Oil
and Checking the
48).
extreme dusty or dirty conditions).
44).
(Figure
Figure 72
3. Rubber outlet valve (dirt
ejection port)
4. Air-cleaner body
72).
g352235