Adding Own Proxy Card - Teletek electronics ECLIPSE 8 User's Operation Manual

ECLIPSE 8/16/32/99 Series – User Operation Manual

4.5 Adding Own Proxy Card

Every user without manager rights in the system can add or remove only his/her own
proxy card for controlling the system. The adding and removing is done in a one and
same menu "5. User Card" (address 5).
To add a card, the user needs to do in sequence:
Text menu/
address
User Code
Put the card over
the reader
Depending on the keyboard used, the visualization on screen is as follows:
LCD 32 and LCD 32 Sensitive
There is no card
The card is registered with a
associated to the code 10-digit unique code.
Put the card over
the reader
The card is recognized on the LCD display and its 10-digit unique code is shown on
screen. If the registration of a card to a user code is successful, after pushing the ENTER
button, a confirmation beep is heard. If the card is associated to a different user, an
"Invalid" message is shown on screen and a rejection signal is heard.
LED 32
There is no card
The card is associated
associated to the code
Put the card over
the reader
The card is recognized on the LED display with digits 1 to 8 permanently lit.
If the registration of a card to a user code is successful, after pushing the ENTER button,
a confirmation beep is heard. If the card is associated to a different user, a rejection signal
is heard.
LED 8/LED 16A
Enter at the address 11 and choose a user number - the LED for zone 1 is blinking on the
display. The registered user card is indicated with digit buttons 1 to 9 lighting on in red.
Note: The proxy reader can be a separate device or built in the keyboard (keyboards
LED32 PR, LCD32 PR). The built-in proxy reader is situated between the MEMORY,
ENTER, "9" and TROUBLES buttons.
In LCD 32S the card reader is situated in the right bottom corner and is indicated with a
"key" symbol.
24