Mec Speed Level 2684 RT Service And Parts Manual page 89

R D M
EAR RIVE OTOR
Refer to "Lift and Support The Machine" in the Introduction section for instructions and
safety precautions.
Upper
Hose Guard
Hose
Fitting
Lower
Hose Guard
Drive
Motor
Assembly
Remove
1. Raise and support the rear end of machine (see Raising the Machine).
2. Remove the wheel and tire assembly to access drive motor.
3. Remove the upper and lower hose guards.
4. Disconnect hose assemblies from drive motor. Immediately cap and plug all openings
to prevent contamination.
5. Remove the hose fitting and the bypass valve solenOId from the motor.
NOTE: The bypass valve solenoid is mounted UP on the left side motor, and mounted DOWN on the right side motor.
6. Remove the cap screws and remove the drive motor from the housing.
Replace
Installation is reverse of removal.
®
• Use Loctite on mounting bolts.
"3084 Speed Level™ Sigma Lift" Service and Parts Manual
Bypass Valve
Solenoid
Motor Housing
M C
E C H A N I C A L O M P O N E N T S
Figure 3-2: Rear Drive Motor
ART_3165
November 2009
Page 3-5