Setting Custom Folds; Batch Counting - Formax FD 340 Operator's Manual

SETTING CUSTOM FOLDS

Example 1: Uneven "Z"
1. Measure the length of panel "A"
2. Adjust the upper fold plate so that the stop plate lines
up with the measurements of the panel "A" i.e. if panel
"A" is 5.25" long slide the stop plate up or down so that it
lines up with the 5.25" mark on the fold plate.
3. Measure the length of panel "B"
4. Adjust the lower fold plate so that the stop plate lines
up with the measurement of panel "B"
5. Load forms and press test. If folds are too long or too
short adjust accordingly.
Example 2: Uneven "C"
1. Measure the length of panel "A" & "B"
2. Adjust the upper fold plate so that the stop plate lines
up with the measurements of panel "A" & "B". i.e. if panel
"A" & "B" are 10" long slide the stop plate up or down so
that it lines up with the 10" mark on the fold plate.
3. Measure the length of panel "B"
4. Adjust the lower fold plate so that the stop plate lines
up with the measurement of panel "B
5. Load forms and press test. If folds are too long or too
short adjust accordingly.

BATCH COUNTING

The batch counter can be set from "0" to "999". Press the "Batch Counting" button to illuminate the "Batch
Counting" light. Press the "-" or "+" buttons to select the number of documents to be folded. Press the "Start"
button. When the counter gets to "0" the machine will stop.
NOTE: The batch counting program will remain on after turning the power off. You must press the Batch
Counting button to turn off the light and cancel the batch count setting.
4
Panel A
Panel B
Panel A
Panel B
must must press the Batch