Setting A Standard Fold - Formax AutoSeal FD 2094 Operator's Manual

SETUP FOR A STANDARD FOLD
Note: See page 30 to help determine fold type
Method 1: CHOOSING FOLD TYPE FIRST
1. To set up for a new fold, press a fold type button. For
example, to set a "Z" fold, press the "Z" fold button. The
display will show the last job sheet length.
2. If the sheet length is not correct, you will have 5 seconds to
begin keying in the new sheet length and press the "ENTER"
button (see below). If the sheet length is correct, you may
immediately press the "ENTER" button, then proceed.
3. When the "ENTER" button is pressed, the fold plates and
stacker will move to their new position. While the motors are
running, a PLEASE WAIT message will be displayed.
4. When the motors have stopped, one of two screens will
be displayed. If the sheet length data was changed, the
single sheet mode screen is displayed.
If the sheet length data was not changed, the count screen
will be displayed.
5. To adjust fold settings, press "PLATE 1" button to adjust
top fold plate and/or "PLATE 2" button to adjust the bottom
fold plate. Use the "+" or "-" keys to adjust settings up or
down, then press "ENTER."
To save, see "Saving Non-Standard Folds into Memory" on
page 17.
Method 2: ENTERING SHEET LENGTH FIRST
1. Setup a new job by pressing the "SHEET MODE" button.
The Sheet Length screen will be displayed showing the last
set sheet length.
You have the following two options: A) Enter a new sheet
length, or B) do nothing.
NOTE: Pressing the enter button will accept the new data
and eliminate any waiting time before moving to the next
function.
17