Method For Replacing Fuel Prefilter Cartridge - Komatsu D37EX-24 Operation & Maintenance Manual

Bulldozer
Table of Contents

Advertisement

MAINTENANCE
12. Add the oil through the oil filler port (F) until the oil level is
between H and L marks on dipstick (G).
13. Run the engine at low idle for a while and then stop it.
14. Check that the oil level is between H and L marks on the
dipstick.
For the checking method, see "METHOD FOR CHECKING
OIL LEVEL IN ENGINE OIL PAN, ADDING OIL (3-126)".
15. After the replacement is completed, close the engine side
cover (4).
REMARK
When the ambient temperature is low, water or emulsified matter may stick to the dipstick, oil filler cap, etc. or
the drained oil may be milky white because of water vapor in the blowby gas. However, if the coolant level is
normal, it is not a problem.
There is no problem even if the emulsified matter cannot be removed completely after changing oil.

METHOD FOR REPLACING FUEL PREFILTER CARTRIDGE

Just after the engine stops, all parts are still very hot, so do not replace the filter immediately. Wait
for all of parts to cool down before starting the work.
High pressure is generated inside the engine fuel piping system when the engine is running.
When replacing the filter, wait for at least 30 seconds after stopping the engine to let the internal
pressure go down before replacing the filter.
Do not bring any open flame close.
NOTICE
Komatsu genuine fuel filter cartridges use a special filter that has highly efficient filtering ability.
When replacing the parts, Komatsu recommends using Komatsu genuine parts.
The common rail fuel injection system used on this machine consists of more precise parts than
those in the conventional injection pump and nozzles. If any cartridge other than a Komatsu genu-
ine filter cartridge is used, dust or dirt may get in and cause problems with the injection system.
Never use a substitute.
When performing the inspection or maintenance of the fuel system, pay more attention than normal
to the entry of dirt. If dirt sticks to any part, use fuel to wash it off completely.
Prepare a filter wrench and a container to catch the fuel.
k
k
WARNING
MAINTENANCE PROCEDURE
4-45

Advertisement

Table of Contents
loading

This manual is also suitable for:

D37px-2485001

Table of Contents