Komatsu D37EX-24 Operation & Maintenance Manual page 255

OPERATION
7.
Place the parking brake lever in FREE position (F).
8.
Set the speed range to 1st or less in variable mode.
9.
Set the travel direction toward the ramps and drive slowly.
The center of gravity of the machine shifts suddenly at the
joint between the ramps and the trailer, and the machine is
unbalanced and becomes unstable. Drive the machine
carefully and slowly.
10. Place the machine at the specified position on the trailer.
METHOD FOR SECURING MACHINE
If the end of blade is out of the trailer, angle the blade.
NOTICE
Be sure to lower the car radio antenna to the stow position.
After loading the machine onto a trailer, secure the machine as follows.
1.
Lower the work equipment gently.
(When transporting with work equipment installed)
2.
Set the work equipment lock lever securely to LOCK posi-
tion (L).
3.
Set the parking brake lever securely to LOCK position (L).
4.
Stop the engine, and remove the starting switch key.
5.
Securely lock the glass window, cab door, engine side cov-
er, hydraulic tank inspection cover, DEF tank filler port cov-
er, and fuel tank inspection cover.
6.
Tie one end of each chain or wire rope of appropriate
strength to the tie-down holes as shown in the figure, and
secure the machine.
Secure the machine so that it will not move during trans-
portation.
In particular, fix the machine securely to prevent it from slipping sideways.
Keep the lifting tools off the tracks.
k k
WARNING
TRANSPORTATION
3-197