Table of Contents
Advertisement
MAINTENANCE
7.
With the user menu on the machine monitor, set "Machine
Setting" to the Fan Reverse Mode.
For setting of the Fan Reverse Mode, see "REVERSE HY-
DRAULIC FAN".
REMARK
Even if Fan Reverse Mode is set while the engine is run-
ning, the fan rotation direction is not reversed.
The screen in the figure is displayed to inform the operator
that the direction of rotation of the fan has not been
changed.
Stop the engine once and perform the steps 3 to 6.
8.
Turn the starting switch (1) to START position and start the
engine.
The hydraulic fan rotates in reverse.
9.
Turn the fuel control dial at High idle (MAX) position, and run the engine at high idle.
Keep running the engine at high idle for approximately 5 minutes.
10. After cleaning, turn the fuel control dial to Low idle (MIN) position.
Run the engine at low idle for approximately 10 seconds.
11. Turn the starting switch (1) to OFF position and stop the engine.
REMARK
•
If dirt is caught in the radiator fins, blow with compressed air to clean.
•
Check that there is no dirt sticking around the turbocharger.
•
In a cold circumstance, perform the cleaning by the hydraulic fan reverse mode within less than 5 mi-
nutes.
If the fan reverse rotation is performed for a long time, the DEF hose may freeze.
12. Install the undercover (6).
13. Close the fuel tank inspection cover (5) on the right side of the machine and the hydraulic tank inspection
cover (4) on the left side.
METHOD FOR CLEANING RADIATOR FIN
•
If compressed air, high-pressure water, or steam hits your body directly or dirt is scattered by the
compressed air, high-pressure water, or steam, there is a danger of personal injury. Wear the pro-
tective equipment such as the protective eyeglasses and dust mask.
•
When performing cleaning, always stop the engine and check that the fan is not rotating. If you
touch the fan when it is rotating, it will cause serious personal injury or death.
k
k
WARNING
MAINTENANCE PROCEDURE
4-29
Advertisement
Chapters
Table of Contents
