Komatsu PC88MR-10 Shop Manual page 460

30 Testing and adjusting
Electrical system
Default (Camera)
(PC88MR-Q1F6-100-K-00-A)
Use the menu of "Default" to check or change
various settings of the machine monitor and
machine.
Camera setting is for setting of camera when the
camera is installed or removed.
1. Selecting a menu
Select "Default" on "Service Menu" screen.
2. Selecting a sub menu
After the "Default" screen is displayed, select
"Camera" by using the function switch or
numeral input switches.
a Selecting method is the same as on the
"Service Menu" screen.
3. Selecting camera setting
After the "Camera" screen is displayed, select a
setting by using the function switch.
Not Use: Camera is not used
30-110
"Use": Images from connected camera are
displayed as a normal image.
[ ]: Reverse images (mirror images if it is
used for rear view monitor) are displayed.
[R]: Normal images (visual images if it is
used for front or side monitor) are displayed.
[F3]: Moves selection downward
[F4]: Moves selection upward.
[F5] Cancels contents of setting before entry
and returns to "Default" screen
[F6]: Enters selection in each line
a You cannot switch camera 1 between [ ] and
[R].
a Enter selection in each line with [F6], and
return to the "Default" screen with [F5], and
then your setting is validated.
a Unless setting is normally set with this
function when the camera is connected, the
graphic mark of camera is not displayed at
[F3] in the operator mode. Accordingly, the
image of the camera cannot be used.
a When the camera is installed, check that the
right and left portions of the displayed image
are correct.
Default (Auto Idle Stop Timer Setting)
Q1GE-100-K-00-A)
Use the menu of "Default" to check or change
various settings of the machine monitor and
machine.
(PC88MR-
PC88MR-10