Komatsu PC88MR-10 Shop Manual page 459

3. Selecting unit
After the "Unit" screen is displayed, select the
unit to be set by using the function switches.
[F3]: Moves selection downward
[F4]: Moves selection upward
[F5]: Cancels selection and returns the
display to Default screen
[F6]: Enters selection and returns the display
to Default screen
a Factory default is the SI Unit .
Default (With/Without Attachment)
100-K-00-A)
Use the menu of "Default" to check or change
various settings of the machine monitor and
machine.
Use the sub menu of "With/Without Attachment" to
configure attachment setting when the attachment
is installed or removed.
1. Selecting a menu
Select "Default" on the "Service Menu" screen.
PC88MR-10
2. Selecting a sub menu
After the "Default" screen is displayed, select
"With/Without Attachment" by using the function
switch or numeral input switches.
a Selecting method is the same as on the
"Service Menu" screen.
3. Selecting With/Without
After the "With/Without Attachment" screen is
displayed, select a setting by using the function
switch.
Without Attachment: An attachment is not
(PC88MR-Q1F4- installed.
With Attachment 1: An attachment is
installed.
[F3]: Moves selection downward
[F4]: Moves selection upward
[F5]: Cancels selection and returns the
display to Default screen
[F6]: Enters selection and returns the display
to Default screen
a When an attachment is installed, if this
setting is not configured correctly, the
attachment setting in the operator mode
cannot be performed. As a result, the
attachment may not work normally or the
hydraulic components may be damaged.
30 Testing and adjusting
Electrical system
30-109