Komatsu PC88MR-10 Shop Manual page 37

Handling of connectors used on engine
Slide, lock type
(FRAMATOME-3, FRAMATOME-2)
Disconnection
1. Slide lock (L1) to the right.
2. While pressing lock (L2), pull out connector (1)
toward you.
a In the case that even if lock (L2) is pressed,
connector (1) cannot be pulled out toward
you unless part A floats, float part A with a
small flat-head screwdriver while pressing
lock (L2), and then pull out connector (1)
toward you.
Connection
1. Insert the connector securely until a click is
heard.
(FRAMATOME-24)
Disconnection
1. Slide down lock (red) (L1).
PC88MR-10
00 Index and foreword
Foreword, safety and general information
2. While pressing lock (L2), pull out connector (1).
a Lock (L2) is located in the back of connector
(1).
Connection
1. Insert the connector securely until a click is
heard.
Pull lock type
(PACKARD-2)
Disconnection
1. Disconnect the connector (2) by pulling lock (B)
(on the wiring harness side) of connector (2)
outward.
00-35