Komatsu PC88MR-10 Shop Manual page 429

Display of Check before starting
044-K-00-A)
When the screen changes to the "check before
starting" screen, the check before starting is
performed for 2 seconds.
a If any abnormalities are detected by the check
before starting, the screen changes to "Display
of warning after check before starting" or
"Display of maintenance time over".
a If no abnormalities are detected by the check
before starting, the screen changes to "Display
of working mode and travel speed check".
a The monitors (6 monitors) on the screen shows
the items currently subjected to the check before
starting.
Display of warning after Check before
starting
(PC88MR-Q180-044-K-01-A)
If any abnormalities are detected in "Check before
starting", the alarm monitor is displayed on the
screen.
a The following figure shows that engine oil level
monitor (a) is warning of low engine oil level.
PC88MR-10
Display of maintenance due time over
(PC88MR-Q180-
Q180-044-K-02-A)
If you find a maintenance item at check before
starting that it is near or overdue the set interval, the
maintenance monitor is displayed for 30 seconds to
urge the operator to perform maintenance.
a This screen is displayed only when the
maintenance function is enabled.
If the remaining time of any item is 30 hours or
less, the yellow icon is displayed. If the
remaining time of any item is 0 hour or less, the
red icon is displayed.
a Perform setting and changing of the
maintenance function in the service mode.
Display of working mode and checking travel
speed
If the check before starting is finished normally, the
screen to check the working mode and travel speed
is displayed for 2 seconds.
a After the display of the working mode and travel
mode settings is finished, the screen changes to
the display of standard screen.
30 Testing and adjusting
(PC88MR-Q180-044-K-03-A)
Electrical system
(PC88MR-
30-79