Lexmark MX617 User Manual page 43

Additional printer setup
Removing a printer hard disk
Warning—Potential Damage: Controller board electronic components are easily damaged by static
electricity. Touch a metal surface on the printer before touching any controller board electronic components
or connectors.
1
Access the controller board.
For more information, see
Note: This task requires a flat‑head screwdriver.
2
Loosen the screws that connect the printer hard disk to the controller board bracket.
3
Unplug the printer hard disk interface cable from the receptacle in the controller board, leaving the cable
attached to the printer hard disk. To unplug the cable, squeeze the paddle at the plug of the interface cable
to disengage the latch before pulling the cable out.
4
Hold the printer hard disk by the edges, and then remove it from the printer.
5
Close the controller board shield, and then close the access door.
"Accessing the controller board" on page 29.
43