Table of Contents
Advertisement
Additional printer setup
Installing an optional card
CAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional hardware
or memory devices sometime after setting up the printer, then turn the printer off, and unplug the power
cord from the electrical outlet before continuing. If you have any other devices attached to the printer,
then turn them off as well, and unplug any cables going into the printer.
Warning—Potential Damage: Controller board electronic components are easily damaged by static
electricity. Touch a metal surface on the printer before touching any controller board electronic components
or connectors.
1
Access the controller board.
For more information, see
2
Unpack the optional card.
Warning—Potential Damage: Avoid touching the connection points along the edge of the card. Doing so
may cause damage.
3
Holding the card by its sides, align the plastic pins (1) on the card with the holes (2) on the controller board.
"Accessing the controller board" on page
29.
32
Advertisement
Table of Contents
