Lexmark MX617 User Manual page 266

Troubleshooting
Supply needed to complete job
Do either of the following:
•
Install the missing supply to complete the job.
•
Cancel the current job.
The device is operating in Safe Mode. Some print options may be disabled
or provide unexpected results.
Touch Continue to clear the message.
Too many flash options installed [58]
1
Turn off the printer.
2
Unplug the power cord from the electrical outlet.
3
Remove the extra flash memory.
4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the printer back on.
Too many trays attached [58]
1
Turn off the printer.
2
Unplug the power cord from the electrical outlet.
3
Remove the extra trays.
4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the printer back on.
Unformatted flash detected [53]
Try one or more of the following:
•
From the printer control panel, touch Continue to stop the defragmentation and continue printing.
•
Format the flash memory.
Note: If the error message remains, then the flash memory may be defective and needs to be
replaced.
Unsupported disk
Remove the unsupported printer hard disk, and then insert a supported one.
266