Table of Contents
Advertisement
Additional printer setup
3
Align the notch (1) on the memory card with the ridge (2) on the connector.
4
Push the memory card straight into the connector, and then push the card toward the controller board wall
until it clicks into place.
5
Close the controller board shield, and then the controller board access door.
Note: When the printer software and any hardware options are installed, you may need to manually add
the options in the printer driver to make them available for print jobs. For more information, see
available options in the print driver" on page
1
48.
2
"Adding
31
Advertisement
Table of Contents
