Lexmark MX617 User Manual page 254

Troubleshooting
Close rear door
Close the rear door of the printer.
Close finisher rear door
Close the rear door of the finisher.
Close front door
Close the front door of the printer.
Close flatbed cover and load originals if restarting job [2yy.xx]
Try one or more of the following:
•
Touch Scan from automatic feeder to continue scanning from the ADF immediately after the last
successful scan job.
•
Touch Scan from flatbed to continue scanning from the scanner glass immediately after the last
successful scan job.
•
Touch Finish job without further scanning to end the last successful scan job.
Note: This does not cancel the scan job. All successfully scanned pages will be processed further
for copying, faxing, or e-mailing.
•
Touch Cancel job to clear the message and cancel the scan job.
Complex page, some data may not have printed [39]
Try one or more of the following:
•
From the printer control panel, touch Continue to ignore the message and continue printing.
•
Cancel current print job.
•
Install additional printer memory.
Configuration change, some held jobs were not restored [57]
Held jobs are invalidated because of the following possible changes in the printer:
•
The printer firmware has been updated.
•
The tray for the print job has been removed.
•
The print job is sent from a flash drive that is no longer attached to the USB port.
•
The printer hard disk contains print jobs that were stored when the hard disk was installed in a different
printer model.
From the printer control panel, touch Continue to clear the message.
254