Allowable Load For Wrist Axis And Wrist Flange; Wrist Flange - YASKAWA MH180 Operating And Maintenance Manual

Allowable load for wrist axis and wrist flange

7 Allowable load for wrist axis and wrist flange
7.1
The dimensions of the wrist flange are shown in the following figure "Wrist flange". To
ensure that the home position marks can be seen at all times, the tool may only be flange-
mounted with the inner diameter. Fitting depth of inside fittings must be 8 mm.
NOTICE
Before mounting a tool, remove anticorrosive coating on the flange. Thinner or light fuel oil
are the most suitable for this purpose.
2 Holes Ø 9
1
2 Holes Ø 10
2
Pitch circle Ø 125
3
6 M10 x 14 threaded holes
4
All dimensions in mm

Wrist flange

10
H7
x 8
H7
x 8
9
Fig. 7-1: Wrist flange
Pitch circle Ø 92
5
Ø 63
6
Ø 160
7
Alignment marks
8
H7
h7
-
7 43