Touratech Front Cargo Rack (If Applicable); Heated Seat (If Applicable); Shovel-Saw (If Applicable); Rewind Starter Handle - BRP LYNX Commander 800R E-TEC Touratech Operator's Manual

CONTROLS, INSTRUMENTS AND EQUIPMENT
30) Touratech Front Cargo
Rack (If Applicable)
The front cargo rack can accommodate
personal articles (luggage).
WARNING
All objects in front cargo rack must
be properly latched. Do not carry
any breakable objects. Excessive
weight in rack may reduce steering
ability.
WARNING
Always readjust suspension ac-
cording to the load.
Front cargo rack is secured on four
points with screws.
fmo2016-002-010_b
1. Front cargo rack
Attach with four screws.
FRONT CARGO RACK SCREWS
6 N•m (53 lbf•in)
______________
62
31) Heated Seat (If
Applicable)
Seat heater switch is installed at front,
near gearshift lever.
Seat heater can be switched ON or
OFF.
fmo2014-003-005_a
1. Seat heater switch
2. Heat OFF
3. Heat ON
32) Shovel-Saw (If
Applicable)
The pruning saw is inside shaft of the
shovel. Shovel-saw is located on RH
side of vehicle.

33) Rewind Starter Handle

Auto-rewind type located on right hand
side of snowmobile. To engage mech-
anism, pull handle slowly until a re-
sistance is felt then pull vigorously.
Slowly release handle.