Drive Belt Guard; Hood - BRP Lynx Commander 800R E-TEC 2018 Operator's Manual

CONTROLS, INSTRUMENTS AND STANDARD EQUIPMENT

24) Drive Belt Guard

Drive Belt Guard Removal
WARNING
NEVER operate engine:
– Without shields and belt guard
securely installed.
– With hood and/or side panels
opened or removed.
NEVER attempt to make adjust-
ments to moving parts while en-
gine is running.
NOTE: Drive belt guard is purposely
made slightly oversize to maintain ten-
sion on its pins and retainers prevent-
ing undue noise and vibration. It is im-
portant that this tension be maintained
when reinstalling.
Remove the tether cord cap from en-
gine cut-off switch.
Open the lower LH side panel. See
procedure in this section.
Remove retaining pin.
mmr2017-039-001_a
TYPICAL
Lift rear portion of drive belt guard then
release from front tabs.
Drive Belt Guard Installation
Insert the tab into the slot and push it
into place
______________
48
mmr2013-034-002_a
1. Belt guard tab
2. Front support slot
Push drive belt guard toward engine
then toward front of vehicle.
mmr2013-034-006_a
Position the rear portion of the belt
guard over the retainer and secure it
using the retaining pin.
mmr2017-039-002

25) Hood

WARNING
Never operate engine with hood
removed from vehicle.